Raytheon ST6000 Plus Specifiche Scaricare il pdf (Pagina 42)

Chapter 4: CodeLock

CodeLock is a personal four-digit security feature designed to protect

your valuable instruments against theft. You dont have to activate the

system, but its there if you need to. You can activate it using any

CodeLock-compatible control unit on your SeaTalk system.

When you first enter a code and activate CodeLock, the code is sent to

all the CodeLock-compatible units on the system. After this, whenever

you power on the system, the units will only start up if they receive the

correct code.

Remember to fix a CodeLock sticker by each instrument, to deter

potential thieves.

4.1 CodeLock Modes

When you set up CodeLock, you can choose whether the code will be

sent automatically or must be entered manually at power on, as follows:

 Auto mode is used when there is a display unit situated in a secure

location, ideally below deck, or one which can be unplugged and

removed to a secure location. You enter your chosen code on this

master unit when you first activate CodeLock. This code is then

automatically sent to all CodeLock-compatible display heads on

SeaTalk, without further intervention, every time the system is

powered on.

 Manual mode is used to provide a higher degree of security,

perhaps when all your instruments are mounted in exposed

locations. In this case, you must enter your personal code every time

the system is switched on. The code can be entered into any

convenient CodeLock-compatible control unit, and is then sent to all

the other compatible units via SeaTalk.

4.2 Setting Up CodeLock

CodeLock is set up and activated on the ST6000 Plus using the

Intermediate Setup options.

Initial Setup

When you first install your ST6000 Plus, CodeLock is set OFF. To

activate CodeLock, refer to the flow diagram on the next page.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 94 95

Nessun commento

Raytheon ST6000 Plus Specifiche Pagina 42